求高手解答！！
实际读取数据为0XFF，即没有读到；

按照SST26VF064B规格部分，
CE# low之后，发送0x9F, 然后就可以读取到manufacturer, device type, and Device ID;

main.c()中读取部分：
uint8_t Data1[1] = {0x9F};
uint8_t Rxdata[3];

HAL_GPIO_WritePin(GPIOG,GPIO_PIN_8,GPIO_PIN_RESET);
HAL_SPI_Transmit(&hspi6,Data1,1,1000);
HAL_SPI_Receive(&hspi6,Rxdata,3,1000);
HAL_GPIO_WritePin(GPIOG,GPIO_PIN_8,GPIO_PIN_SET);

eliucheng-11224 发表于 2016-9-6 11:58
怎么样？解决了没有？

OK了，HW设计DATA IN/OUT反调了；

void MX_SPI6_Init(void)
{

  hspi6.Instance = SPI6;
  hspi6.Init.Mode = SPI_MODE_MASTER;
  hspi6.Init.Direction = SPI_DIRECTION_2LINES;
  hspi6.Init.DataSize = SPI_DATASIZE_8BIT;
  hspi6.Init.CLKPolarity = SPI_POLARITY_HIGH;
  hspi6.Init.CLKPhase = SPI_PHASE_2EDGE;
  hspi6.Init.NSS = SPI_NSS_SOFT;
  hspi6.Init.BaudRatePrescaler = SPI_BAUDRATEPRESCALER_256;
  hspi6.Init.FirstBit = SPI_FIRSTBIT_MSB;
  hspi6.Init.TIMode = SPI_TIMODE_DISABLE;
  hspi6.Init.CRCCalculation = SPI_CRCCALCULATION_DISABLE;
  hspi6.Init.CRCPolynomial = 10;
  if (HAL_SPI_Init(&hspi6) != HAL_OK)
  {
    Error_Handler();
  }

}

怎么样？解决了没有？