下午拿到STM32F302 Nucleo的板子，回来后速速体验了下mbed。导入的Program是从板子向PC发送数据
1.先安装ST-Link驱动
http://mbed.org/teams/ST/wiki/ST-Link-Driver
具体安装参见Installation提示
2.更新ST-Link的Firmware
更新固件之间，必须先安装ST-Link的驱动

3.进入mbed IDE
http://mbed.org/compiler/#nav:/;

选择一个工程模板，下拉列表中很多工程模板，如下图：

4.Compile产生二进制.bin文件
#include "mbed.h"
//------------------------------------
// Hyperterminal configuration
// 9600 bauds, 8-bit data, no parity
//------------------------------------
Serial pc(SERIAL_TX, SERIAL_RX);
 
DigitalOut myled(LED1);
 
int main() {
  int i = 1;
  pc.printf("Hello World !\n");
  while(1) { 
      wait(1);
      pc.printf("This program runs since %d seconds.\r\n", i++);
      myled = !myled;
  }
}
5.下载到NUCLEO盘符中，复位下程序就开始跑起来，最终在串口中打印出
..........
This program runs since 1830 seconds.
This program runs since 1831 seconds.
This program runs since 1832 seconds.
...........

 
 

 

有没有IAR上的源程序呀，求分享！