P-NUCLEO-WB55.USBDongle开发板升级FUS和无线协议栈失败问题请教
按照官网提供的下面步骤 升级P-NUCLEO-WB55.USBDongle单板的FUS和无线协议栈后，单板在sw2 to boot0下，stm32cubeprogrammer选择usb模式无法再识别到DFU设备，感觉是FUS升级坏了。有个疑问：按照介绍，stm32wb5x_FUS_fw.bin 是烧录在 0x080EC000位置，而stm32wb5x_BLE_Stack_fw.bin是烧录在0x080cb000位置，这两个位置之间相差0x21000，可是stm32wb5x_BLE_Stack_fw.bin文件的大小有160KB左右，这样烧录stm32wb5x_BLE_Stack_fw.bin时 不就会把FUS空间覆盖了吗？
[*]STEP 1: Use STM32CubeProgrammer
[*]Version 2.0 or higher.
[*]It gives access to Firmware Upgrade Service (FUS) (AN5185 : ST firmware upgrade services for STM32WB Series.) through Bootloader.
[*]It is currently available as Command Line Interface (CLI) mode.
[*]STEP 2: Access to Bootloader USB Interface (system flash)
[*]Boot mode selected by Boot0 pin set to VDD
[*]For P-NUCLEO-WB55.Nucleo :
[*]Jumper between CN7.5(VDD) and CN7.7(Boot0)
[*]Power ON via USB_USER and Jumper JP1(USB_MCU)
[*]For P-NUCLEO-WB55.USBDongle :
[*]Move switch SW2 to Boot0
[*]Connect P-NUCLEO-WB55.USBDongle
[*]STEP 3 : Delete current wireless stack :
[*]STM32_Programmer_CLI.exe -c port=usb1 -fwdelete
[*]STEP 4 : Read and upgrade FUS Version
[*]STM32_Programmer_CLI.exe -c port=usb1 -r32 0x20030030 1
[*]0x20030030 : 00050300 : FUSv0.5.3 => Must be updated using STEP 5.
[*]0x20030030 : 01000100 or 01000200 : FUSv1.0.x => Up to date, you can download the new wireless stack using STEP6.
[*]STEP 5 : Download new FUS :
[*]STM32_Programmer_CLI.exe -c port=usb1 -fwupgrade firstinstall=0
Please check Firmware Upgrade Services Binary Table for Install@ parameter depending of the binary.[*]STEP 6 : Download new wireless stack :
[*]STM32_Programmer_CLI.exe -c port=usb1 -fwupgrade firstinstall=1
Please check Wireless Coprocessor Binary Table for Install@ parameter depending of the binary.[*]STEP 7 : Revert STEP 2 procedure to put back device in normal mode.
页:
[1]