zhwd102198 发表于 2016-1-26 08:41:52

http://upload.semidata.info/sns.eefocus.com/st/document/category/632.jpg

有LTDC功能,主频高达180M

主要使用在继电器保护装置上!

沐紫 发表于 2016-1-26 09:03:55

zhwd102198 发表于 2016-1-26 08:41
有LTDC功能,主频高达180M

主要使用在继电器保护装置上!

再上传一个文档才行哦

Ljmp 发表于 2016-1-26 09:17:20

哟哟哟,不错哦!!!

laoguoex 发表于 2016-1-26 09:20:11



1. 图片见附件
2. 产品型号: STM32F103RC. 资料见附件
   特性:
   1. NVIC外部中断功能以及优先级配置起来很不错
   2. GPIO可灵活配置
3. 设计: 开发过智能卡读卡器和智能卡之间的数据抓取仪器





枫飞 发表于 2016-1-26 09:25:45

https://www.stmcu.org.cn/module/forum/data/attachment/forum/201412/08/211504onvomzk4emnnsmkn.jpg
NUCLEO-F072RB
特性很多啦
The STM32 Nucleo board provides an affordable and flexible way for users to try out new ideas and build prototypes with any STM32 microcontroller line, choosing from the various combinations of performance, power consumption and features. The Arduino™ connectivity support and ST Morpho headers make it easy to expand the functionality of the STM32 Nucleo open development platform with a wide choice of specialized shields. The STM32 Nucleo board does not require any separate probe as it integrates the ST-LINK/V2-1 debugger and programmer. The STM32 Nucleo board comes with the STM32 comprehensive software HAL library together with various packaged software examples, as well as direct access to mbed online resources.


Key Features

    STM32 microcontroller with LQFP64 package
    Two types of extension resources
    Arduino Uno Revision 3 connectivity
    STMicroelectronics Morpho extension pin headers for full access to all STM32 I/Os
    mbed-enabled (http://mbed.org)
    On-board ST-LINK/V2-1 debugger/programmer with SWD connector
    selection-mode switch to use the kit as a standalone ST-LINK/V2-1
    Flexible board power supply
    USB VBUS or external source(3.3 V, 5 V, 7 - 12 V)
    Power management access point
    Three LEDs
    USB communication (LD1), user LED (LD2), power LED (LD3)
    Two push buttons: USER and RESET
    USB re-enumeration capability: three different interfaces supported on USB
    Virtual Com port
    Mass storage
    Debug port
    Supported by wide choice of Integrated Development Environments (IDEs) including IAR™, Keil®, GCC-based IDEs

最欣赏的是对于外设引脚全部引出,经典的开发部分+stlink部分,在原先discover板子的基础上精简了很多
外壳反面对于这块板子的使用也做了些简要介绍。

用于实际项目,主要用到串口、usb口、驱动led、按键、oled、lcd12864、各种传感器等各种

skymaze 发表于 2016-1-26 09:26:52

本帖最后由 skymaze 于 2016-1-26 09:28 编辑

1STM32F303 DISCOVERY
2.STM32F303
具有高性能、实时功能、数字信号处理、低功耗与低电压操作特性,做飞行器,跑个滤波算法妥妥的。


3.智能家居主控,四轴飞行器

w919720378 发表于 2016-1-26 09:29:16

使用f103rct,没拿过官方开发板,都是自己折腾的。使用stm32开发过两个项目,一个是电机转速表,一个是云台控制板。

songdalong 发表于 2016-1-26 09:31:40

1、   晒出你使用过的STM32开发板/芯片图片(如果还未使用过,可从官网寻找);
使用了discovery开发板;
2、   说明该STM32产品型号,列举其一项或者多项特性,同时附件上传一篇该型号产品的资料(官方文档或者网络上的文章分享均可,点击立刻下载官方文档)
实际使用了STM32F103RC的芯片,选择这颗芯片,主要的特点是性价比高,芯片资料齐全,学习资料多,开发起来简单易用。
3、   基于STM32你做过哪些设计?(如没有则不写)
采用了STM32F103RC做过低电压采集器,相机外部控制器等。

colin2135 发表于 2016-1-26 09:49:36

1.stm32f070rb NUCLEO

2.产品特性
   128KB FLASH,16KB SRAM
   两组扩展座子,可连接ARDUNIO
   板载了STLINK/V2-1,可在mbed进行在线编程
   2组I2C接口
   4组UART接口
11个定时器


3.用于做过的项目

根据项目需要,需要用到多组串口,但由于主控板的串口都被使用。
所以采用STM32F070RBT6作为扩展。
扩展方式:
做一个类似USB HUB的 UART HUB,STM32F070以SPI方式与主控板进行连接,将四组串口接收到的数据存放于SRAM缓存中,等待主控通过SPI来读取

linyu0395 发表于 2016-1-26 09:50:49

1、   晒出你使用过的STM32开发板/芯片图片(如果还未使用过,可从官网寻找);

2、   说明该STM32产品型号,列举其一项或者多项特性,同时附件上传一篇该型号产品的资料(官方文档或者网络上的文章分享均可,点击立刻下载官方文档)

ows: 2; word-spacing: 0px; -webkit-texFeatures
 Core: ARM® 32-bit Cortex™-M0 CPU,
frequency up to 48 MHz
 Memories
– 16 to 64 Kbytes of Flash memory
– 8 Kbytes of SRAM with HW parity checking
 CRC calculation unit
 Reset and power management
– Voltage range: 2.0 V to 3.6 V
– Power-on/Power down reset (POR/PDR)
– Programmable voltage detector (PVD)
– Low power modes: Sleep, Stop, Standby
– V
BAT supply for RTC and backup registers
 Clock management
– 4 to 32 MHz crystal oscillator
– 32 kHz oscillator for RTC with calibration
– Internal 8 MHz RC with x6 PLL option
– Internal 40 kHz RC oscillator
 Up to 55 fast I/Os
– All mappable on external interrupt vectors
– Up to 36 I/Os with 5 V tolerant capability
 5-channel DMA controller
 1 x 12-bit, 1.0 μs ADC (up to 16 channels)
– Conversion range: 0 to 3.6 V
– Separate analog supply from 2.4 up to 3.6
 One 12-bit D/A converter
 Two fast low-power analog comparators with
programmable input and output
 Up to 18 capacitive sensing channels
supporting touchkey, linear and rotary touch
sensors
 Up to 11 timers
– One 16-bit 7-channel advanced-control
timer for 6 channels PWM output, with
deadtime generation and emergency stop
– One 32-bit and one 16-bit timer, with up to
4 IC/OC, usable for IR control decoding
– One 16-bit timer, with 2 IC/OC, 1 OCN,
deadtime generation and emergency stop
– Two 16-bit timers, each with IC/OC and
OCN, deadtime generation, emergency
stop and modulator gate for IR control
– One 16-bit timer with 1 IC/OC
– Independent and system watchdog timers
– SysTick timer: 24-bit downcounter
– One 16-bit basic timer to drive the DAC
 Calendar RTC with alarm and periodic wakeup
from Stop/Standby
 Communication interfaces
– Up to 2 I2C interfaces; one supporting Fast
Mode Plus (1 Mbit/s) with 20 mA current
sink, SMBus/PMBus and wakeup from STOP
– Up to two USARTs supporting master
synchronous SPI and modem control; one
with ISO7816 interface, LIN, IrDA
capability, auto baud rate detection and
wakeup feature
– Up to two SPIs (18 Mbit/s) with 4 to 16
programmable bit frame, 1 with I2S
interface multiplexed
 HDMI CEC interface, wakeup on header
reception
 Serial wire debug (SWD)
 96-bit unique ID
 All packages ECOPACK®2










3、   基于STM32你做过哪些设计?(如没有则不写)
做过智能家居的网关,灯光控制器,窗帘控制,红外转发器,手持设备


页: 29 30 31 32 33 34 35 36 37 38 [39] 40 41 42 43 44 45
查看完整版本: 【活动】庆祝STM32出货量超10亿颗,开发板送不停!